After using pot descaling gel to remove stubborn stains, timely cleaning of the residue is not only related to the cleanliness of the pot, but also affects the subsequent cooking safety and the service life of the pot. When cleaning the residue, you need to follow the correct steps and methods to ensure that the gel traces are completely removed.
After completing the descaling operation, you cannot immediately rinse the hot pot with cold water to avoid deformation or cracking of the pot body due to excessive temperature difference. The pot should be placed in a safe and stable place first, and wait for it to cool naturally to near room temperature to reduce damage to the pot caused by sudden temperature changes. In this process, the gel and dirt can also react fully, which is convenient for subsequent rinsing.
Then, inject an appropriate amount of warm water into the pot, and the amount of water should be enough to cover the area where the pot descaling gel is used. Warm water helps dissolve the gel residue and softens its sticky substances more easily than cold water. After filling the water, you can gently wipe the surface of the pot with a soft dishcloth or sponge, especially focusing on wiping the area where the pot descaling gel is applied. The action should be gentle to prevent scratching the coating or surface of the pot.
For stubborn gel residue, it may be difficult to remove it simply by wiping. At this time, you can use a neutral detergent to assist in cleaning. Squeeze a small amount of detergent on a dishcloth and repeatedly wipe the residual area in a circular motion. With the help of the detergent's cleaning power, the sticky components of the gel are broken down. But be careful to avoid using detergents containing abrasive particles or strong alkalinity, which may damage the material of the pot.
After wiping, rinse the pot thoroughly with plenty of clean water. When rinsing, you need to keep turning the pot to ensure that the water flow can flush every corner and completely rinse the residual gel and detergent. At the same time, carefully check the edges and bottom of the pot, which are easy to hide dirt, to prevent gel or detergent residue. If conditions permit, you can use running water to rinse for better cleaning results.
After rinsing, do not let the pot dry naturally. Residual water stains may leave water marks on the surface of the pot and even breed bacteria. Immediately wipe the inside and outside of the pot with a clean dry cloth or kitchen paper towel, especially the bottom of the pot, to avoid water stains that may cause rust or affect the heating effect when it is used next time. If the pot is made of special materials, such as some non-stick coating pots, it should be wiped dry in time to protect the coating from water stains.
Finally, place the cleaned and dried pots in a ventilated and dry place. Avoid stacking pots directly or contacting them with other wet items to prevent stains or odors from being stained again. Check the stored pots regularly to ensure that they are always kept clean and dry, ready for the next use. Only by completing each step of cleaning residues in a standardized manner can the dual effects of pot cleaning and maintenance be truly achieved.
